Skip to the beginning of the images gallery

CS2RS-D507 (24-50 Vdc, 0.5-7Amp，Modbus based on RS485)

£142.57 £118.81

Label	Description	Type	Size	Download
Leadshine-Motion-Studio-Stepper-V1.3.10	A free software which allows the user to modify the parameters of Leadshine's stepper and servo drives, performance adjustments, trial run, monitor the status etc.	zip	29 MB	Download
CS2RS_Series_User_Manual_V1.5	User Manual for the CS2RS Stepper drive that works over Modbus RTU.	pdf	2.8 MB	Download
CS2RS-D503,507_3D	3D model of the CS2RS-D503 and the CS2RS-D507	zip	1.9 MB	Download
CS2RS-D503,507_3D	3D Model of the CS2RS-D503 and 507	zip	1.9 MB	Download
Leadshine_Motion_Studio_Stepper_V1.3.10	Configuration software for the Leadshine range of stepper drivers	zip	29 MB	Download

Categories: CS2RS Closed Loop Drive with Modbus Control,

SKU

CS2RS-D507

-2 in stock. (If not in stock expect 4-5 weeks)

More Information on Shipping

More Information
Country of Manufacture	China
Manufacturer	Leadshine
Voltage Range	24V~50VDC

Details

CS2RS Series are closed loop stepper drive based on standard Modbus RTU protocol, using RS485 communication can network up to 31 axes, built-in PR feature with 16-segment position table (PR Mode). They can not only solve the problem of step loss in the open loop stepper system, but also can save additional controllers in most of point-to-point applications, to greatly enhance system reliability and reduce the cost. CS2RS Series also support the feature of teaching, the operation modes of Profile Position, Profile Velocity and Homing. CS2RS-D503 can power 2-phase NEMA 17, 23, 24 stepper motors with 1000 ppr to 5000 ppr incremental encoders.

No loss of step, no hunting, no torque reservation.
CANopen over EtherCAT (CoE) with full support of CiA402,100Mbps full-duplex.
Operation modes: profile position, profile velocity, cyclic synchronous position, homing.
7 configurable digital inputs, 3 optically isolated digital outputs include brake output.
Low noise and vibration, smooth motion.
USB port for Leadshine software connection.
Two 7-segment display velocity or slave ID or operation mode or error code.
Over voltage, over current and position following error, encoder cable error, etc. protections.

Model	CS3E-D507
Series	CS3E-
Command Source	EtherCAT
Operation Voltage (VDC)	20-50VDC
Output Current (A, Peak)	7
Input Frequency (KHz, Max.)	10
Logical Voltage (VDC)	12-24
# of Inputs	7
# of Outputs	3
Characteristics	Standard

Downloads

Leadshine-Motion-Studio-Stepper-V1.3.10

A free software which allows the user to modify the parameters of Leadshine's stepper and servo drives, performance adjustments, trial run, monitor the status etc.

Download >